arXiv.itsnick.co

an independent field guide to 23 million papers from arXiv & OpenAlex — not affiliated with arXiv.org

Author

Timo Muscheid

7 papers · 2023–2026

2023: 12024: 22025: 32026: 1
2023peak 3 in 20252026

Frequent co-authors

Papers

showing 1–7 of 7 RSS

Cross-Chip Partial Reconfiguration for the Initialization of Modular and Scalable Heterogeneous Systems

Marvin Fuchs, Hendrik Krause, Timo Muscheid +3 more

Hardware and Architecture · IEEE Transactions on Nuclear Science · · cited 3× · DOI ↗ · more like this ·

The almost unlimited possibilities to customize the logic in a field-programmable gate array (FPGA) is one of the main reasons for the versatility of these devices. Partial reconfiguration exploits this capability even further by allowing to replace logic in predefined FPGA regions at runtime. This is especially relevant in heterogeneous system-on-chip (SoC), combining FPGA fabric with conventional processors on a single die. Tight integration and supporting frameworks, such as the FPGA subsystem in Linux, facilitate use, for example, to dynamically load custom hardware accelerators. Although this example is one of the most common use cases for partial reconfiguration, the possible applications go far beyond. We propose to use partial reconfiguration in combination with the advanced extensible interface (AXI) Chip2Chip (c2c) cross-chip bus to extend the resources of heterogeneous…

Adaptive carrier signal synthesis for frequency-division multiplexed cryogenic detector readout

Timo Muscheid, Benedikt Keppner, Daniel Crovo +5 more

physics.ins-det · · cited 0× · arXiv ↗ · more like this ·

Frequency-domain multiplexing is a fundamental technology for readout of cryogenic detector arrays on a single transmission line. Synthesizing a large number of static carrier tones for resonator stimulation eventually drives the cryogenic low-noise amplifier beyond its P1dB, introducing detector signal distortion. Scaling array sizes to O(10^6) detector pixels therefore demands minimizing the total power on the transmission line by continuous tracking of the resonances, which requires the readout electronics to be capable of updating the carrier tones dynamically. This work presents an scalable FPGA-based implementation for carrier signal synthesis based on a numerically controlled oscillator and a polyphase filter bank, enabling real-time frequency adaptivity as well as frequency resolution of 4 mHz to precisely tune the operating point, while simultaneously reducing resource usage…

Improved limit on the effective electron neutrino mass with the ECHo-1k experiment

Fabienne Adam, Felix Ahrens, Luis E. Ardila Perez +56 more

hep-ex · · cited 0× · arXiv ↗ · more like this ·

The effective electron neutrino mass can be determined by analyzing the endpoint region of the $^{163}$Ho electron capture spectrum, provided a measurement with high energy resolution and high statistics using calorimetric techniques. Here, the Electron Capture in $^{163}$Ho collaboration, ECHo, presents an analysis of the most precise $^{163}$Ho spectrum currently available, obtained with the ECHo-1k experiment and comprising about 200 million events. A very low background rate of $B=9.1(1.3)\times 10^{-6}$ /eV/pixel/day was achieved allowing for a reliable analysis of the endpoint region. The derived endpoint energy $Q = 2862(4)$ eV is in excellent agreement with the one independently determined via Penning-trap mass spectrometry of $Q=2863.2(6)$ eV [1]. The upper limit of the effective electron neutrino mass is improved by almost a factor 2 compared to the lowest current value [2]…

Cross-Chip Partial Reconfiguration for the Initialisation of Modular and Scalable Heterogeneous Systems

Marvin Fuchs, Hendrik Krause, Timo Muscheid +3 more

physics.ins-det · · cited 0× · arXiv ↗ · more like this ·

The almost unlimited possibilities to customize the logic in an FPGA are one of the main reasons for the versatility of these devices. Partial reconfiguration exploits this capability even further by allowing to replace logic in predefined FPGA regions at runtime. This is especially relevant in heterogeneous SoCs, combining FPGA fabric with conventional processors on a single die. Tight integration and supporting frameworks like the FPGA subsystem in Linux facilitate use, for example, to dynamically load custom hardware accelerators. Although this example is one of the most common use cases for partial reconfiguration, the possible applications go far beyond. We propose to use partial reconfiguration in combination with the AXI C2C cross-chip bus to extend the resources of heterogeneous MPSoC and RFSoC devices by connecting peripheral FPGAs. With AXI C2C it is easily possible to link…

DTS-100G -- A versatile heterogeneous MPSoC board for cryogenic sensor readout

Timo Muscheid, Artur Boebel, Nick Karcher +7 more

physics.ins-det · · cited 0× · arXiv ↗ · more like this ·

Heterogeneous devices such as the Multi-Processor System-on-Chip (MPSoC) from Xilinx are extremely valuable in custom instrumentation systems. This contribution presents the joint development of a heterogeneous MPSoC board called DTS-100G by DESY and KIT. The board is built around a Xilinx Zynq Ultrascale+ chip offering all available high-speed transceivers using QSFP28, 28 Gbps FireFly, FMC, and FMC+ interfaces. The board is not designed for a particular application, but can be used as a generic DAQ platform for a variety of physics experiments. The DTS-100G board was successfully developed, built, and commissioned. ECHo-100k is the first experiment which will employ the board. This contribution shows the system architecture and explains how the DTS-100G board is a crucial component in the DAQ chain.

CryoDE: a Digital Cryogenic Detector Emulator for Microwave SQUID Multiplexed Systems

Timo Muscheid, Daniel Crovo, Robert Gartmann +4 more

physics.ins-det · · arXiv ↗ · more like this ·

Simultaneous readout of large-scale cryogenic detector arrays relies on multiplexing schemes such as the FDM (Frequency-Division Multiplexing) with microwave SQUID multiplexers and highly customized readout electronics. In traditional detector systems, where mixed-signal ASICs are used in detector front-ends and typically provide a digital interface, HIL (Hardware-in-the-Loop) testing can be readily implemented by reusing the existing digital logic of the front-end for emulation purposes. Such straightforward emulation is not possible for FDM low-temperature detectors, where the sensor signal is encoded in a high-frequency microwave carrier via a two-stage modulation scheme depending on the cryogenic resonators and the SQUID response. To address this challenge, we present CryoDE, a digital cryogenic-detector emulator for microwave SQUID multiplexed detector systems. CryoDE generates the…

SoCks - Simplifying Firmware and Software Integration for Heterogeneous SoCs

Marvin Fuchs, Lukas Scheller, Timo Muscheid +2 more

cs.AR · · arXiv ↗ · more like this ·

Modern heterogeneous System-on-Chip (SoC) devices integrate advanced components into a single package, offering powerful capabilities while also introducing significant complexity. To manage these sophisticated devices, firmware and software developers need powerful development tools. However, as these tools become increasingly complex, they often lack adequate support, resulting in a steep learning curve and challenging troubleshooting. To address this, this work introduces System-on-Chip blocks (SoCks), a flexible and expandable build framework that reduces complexity by partitioning the SoC image into high-level units called blocks. SoCks builds each firmware and software block in an encapsulated way, independently from other components of the image, thereby reducing dependencies to a minimum. While some information exchange between the blocks is unavoidable to ensure seamless…