Author

Timing Qu

8 papers · 2013–2025

2013peak 2 in 20252025

Frequent co-authors

Papers

showing 1–8 of 8 RSS

Memory-based consensus control for multi-agent systems with time-varying topology and communication constraints

Timing Qu Fei Liang, Zehui Xiao, Yunfa Wu +2 more

Computer Networks and Communications · ISA Transactions · 28 Nov 2024 · cited 5× · DOI ↗ · more like this ·

This paper focuses on the design of event-triggered observer-based heterogeneous memory controllers for leader-following multi-agent systems with time-varying topology. In order to save limited on-board resources, a novel adaptive event-triggered strategy based on the nonlinear transformation law of the estimation error is proposed in this paper, which can effectively reduce some unnecessary data transmission due to small fluctuations after the estimation error converges. Then, a more general topology structure described by an interval type-2 fuzzy model is adopted, which contains both nonlinear time-varying law and uncertain parameters. Taking into account the differences in the interactions between various agents, the heterogeneous fuzzy-dependent controllers with past state measurements are constructed to further improve consensus performance. Moreover, some sufficient conditions are…

A Surrogate model for High Temperature Superconducting Magnets to Predict Current Distribution with Neural Network

Mianjun Xiao, Peng Song, Yulong Liu +7 more

cs.LG · September 2025 · arXiv ↗ · more like this ·

Finite element methods (FEM) for high-temperature superconducting (HTS) magnets become time-consuming at larger scales, restricting the rapid optimization of meter-scale REBCO solenoids. In this work, a surrogate model based on a fully connected residual neural network (FCRN) is developed to predict the current density distribution in REBCO solenoids. Trained on datasets generated from FEM simulations by the T-A formulation, the FCRN model is evaluated under both fast ramping and steady-state scenarios, showing a lower validation loss than the fully connected network (FCN). When extrapolating geometric parameters beyond the training set, the model achieves a relative error of below 10 % for magnetization losses in Case 1 and an average error of 1.2 % for the central magnetic field in Case 2. Furthermore, deploying the steady-state surrogate model for rapid magnet design found the…

Experimental and numerical study on current distribution in parallel co-wound no-insulation coils

Yulong Liu, Peng Song, Mianjun Xiao +4 more

physics.app-ph · 11 Jul 2025 · arXiv ↗ · more like this ·

No-insulation (NI) coils are known for their high thermal stability and self-protection features due to turn-to-turn contacts. Parallel co-winding is a promising method to reduce the charging delay of NI coils while maintaining thermal stability, demonstrating significant potential for applications in fusion and other large-scale or high-field magnets. The non-uniform current distribution among parallel superconducting tapes in parallel co-wound NI coils may lead to thermal and mechanical stability issues. In this work, we conducted current measurement experiments on small parallel co-wound NI REBCO coils to investigate the non-uniform current distribution and its influencing factors. The parallel tapes in the input and output sections of the test coils were separated and a series of Rogowski coils was used to measure the current in each tape during ramping charging process. We combined…

Evaluation of the effect of edge cracks on critical current degradation in REBCO tapes under tensile stress

Zhirong Yang, Peng Song, Mingzhi Guan +2 more

cond-mat.supr-con · 18 Oct 2021 · arXiv ↗ · more like this ·

The slitting process used for fabrication of REBa2Cu3Ox (REBCO, RE=Rare earth) tapes of required width will greatly improve production efficiency and reduce production costs. However, edge cracks induced by the slitting process of wide REBCO tapes may cause the premature degradation under a extremely high hoop (tensile) stress in high-field magnets. It is necessary to evaluate the edge cracks of REBCO tapes on the critical current (Ic) degradation. This work aims to evaluate the effect of edge cracks on the Ic performance under tensile stress. Ic degradation under artificial cracks was measured to validate the applicability of linear elastic fracture mechanics for the REBCO film. Linear elastic fracture mechanics was used to get the mixed stress intensity factor of multiple edge oblique cracks. A model considering edge crack properties angle \b{eta}, spacing d, and length a is…

Screening current effect on the stress and strain distribution in REBCO high-field magnets: experimental verification and numerical analysis

Yufan Yan, Canjie Xin, Yunfei Tan +1 more

physics.app-ph · September 2019 · arXiv ↗ · more like this ·

Besides screening-current-induced magnetic fields (SCIF), the shielding effect in high-Tc coated conductors also has an strong influence on its strain distribution in a coil winding, especially during high-field operations. To demonstrate this phenomenon, a special experimental setup was designed. With an LTS background magnet and a small HTS insert coil, we were able to carry out direct observations on the hoop strains of a 10-mm wide REBCO sample. Measured data was compared against numerical solutions solved by electromagnetic models based on T -A formulation and homogeneous mechanical models, showing good agreements. An analytical expression was proposed to estimate the maximum radial Lorentz force considering shielding effect. Using the developed numerical models, we further studied the potential effects of two of the mostly investigated methods, which were formerly introduced to…

Accurate evaluation of the fractal dimension based on a single morphological image

Feng Feng, Binbin Liu, Xiangsong Zhang +4 more

cond-mat.mtrl-sci · 25 Jan 2018 · arXiv ↗ · more like this ·

Fractal dimension (D) is an effective parameter to represent the irregularity and fragmental property of a self-affine surface, which is common in physical vapor deposited thin films. D could be evaluated through the scaling performance of surface roughness by using atomic force microscopy (AFM) measurements, but lots of AFM images with different scales (L) are needed. In this study, a surface roughness prediction (SRP) method was proposed to evaluate D values of a single AFM image, in which the roughness at smaller L was estimated by image segmentation with flatten modification. Firstly, a series of artificial fractal surfaces with ideal dimension (Di) values ranging from 2.1 to 2.9 were generated through Weierstrass-Mandelbrot (W-M) function, in order to compare SRP method with traditional methods such as box counting method and power spectral density method. The calculated dimension…

Critical Current Survival in YBCO Superconducting Layer of the Delaminated Coated Conductor

Feng Feng, Qishu Fu, Timing Qu +8 more

cond-mat.supr-con · 27 Dec 2016 · arXiv ↗ · more like this ·

High temperature superconducting coated conductor (CC) could be practically applied in electric equipment due to its favorable mechanical properties and the critical current performance of YBCO superconducting layer. It is well known that CC could be easily delaminated because of its poor stress tolerance in thickness direction, i.e. along the c-axis of YBCO. Commonly, a stack including YBCO layer and silver stabilizer could be obtained after the delamination. It would be interesting to investigate the superconducting properties of the delaminated stack, since it could also be considered as a new type of CC with the silver stabilizer as the buffer layer, which is quite different from the oxide buffer layers in the traditional CC and might lead to new applications. In this study, a CC sample was delaminated by liquid nitrogen immersing. A Hall probe scanning system was employed to…

A Low-Fluorine Solution with the F/Ba Mole Ratio of 2 for the Fabrication of YBCO Films

Wei Wu, Feng Feng, Yue Zhao +8 more

cond-mat.mtrl-sci · 24 Sep 2013 · arXiv ↗ · more like this ·

In the reported low-fluorine MOD-YBCO studies, the lowest F/Ba mole ratio of the precursor solution was 4.5. However, further lowering the F/Ba ratio is important according to the researches of YBCO thick film. On the other hand, the F/Ba ratio is necessary to be at least 2 for the full conversion of the Ba precursor to BaF_2 to avoid the formation of BaCO_3, which is detrimental to the superconducting performance. In this study, a novel solution with the F/Ba mole ratio of 2 was developed, in which the fluorine content was only about 10.3% of that used in the conventional TFA-MOD method. Attenuated total reflectance-Fourier transformed-infrared spectra(ATR-FT-IR) revealed that BaCO_3 was remarkably suppressed in the as-pyrolyzed film and eliminated at 700 Celsius degree. Thus YBCO films with a critical current density (J_c) over 5 MA cm^{-2} (77 K, 0 T, 200 nm thickness) could be…